Error code · Washer

Whirlpool Washer Code A10: Slow or No Drain

A10 is a drain problem code on Whirlpool washers, in guidance that does not name a series. It means the washer did not drain water as it should, so you will see A10 on the display…

Medium · inspection needed

Book a Service Call (713) 589-6107

Code: A10
Appliance: Washer
Brand: Whirlpool
Warranty: 30-day workmanship

What A10 means

A10 is a drain problem code on Whirlpool washers, in guidance that does not name a series. It means the washer did not drain water as it should, so you will see A10 on the display and water may remain in the tub. The owner's questions all concern the drain hose: whether it is kinked, frozen, clogged, or set higher than 55 inches (1.4 m) above the floor. The guidance asks you to unplug the washer or disconnect power before you check any of these.

Common causes of A10

Kinked drain hose
Frozen drain hose
Clogged drain hose
Drain hose set higher than 55 inches above the floor

✓ One safe check you can try

1. Unplug the washer or disconnect its power. 2. Look along the drain hose for kinks or a crushed section. 3. Check that the hose is not frozen. 4. Make sure the hose is not clogged where it meets the standpipe. 5. Check that the hose is not more than 55 inches above the floor, then restore power.

! Why to stop there

Clear hoses at the right height leave the pump and its circuit as the next place to look
We test the drain pump, its filter and the control on site
The price is given in writing first, and the repair carries a 30-day workmanship warranty

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

LdLWhirlpool Top-Load Washer Code LdL: Lid Fails to Lock Sense and Wash FlashingWhirlpool Top-Load Washer Sense and Wash Lights Flashing: Unbalanced Spin LdUWhirlpool Top-Load Washer Code LdU: Lid Is Unable to Unlock Spin Light FlashingWhirlpool Top-Load Washer Spin Light Blinking: The Basket Is Off Balance LFWhirlpool Top-Load Washer Code LF: Tub Is Too Slow to Fill SudWhirlpool Washer Sud or Sd: Too Many Suds in the Tub LidWhirlpool Top-Load Washer Display Lid: Lid Opened During the Cycle uLWhirlpool Top-Load Washer Code uL: Unbalanced Load Needs Rearranging

A10A10 questions

Why is there water left in the tub with A10?

A10 reports that the water did not drain. The hose is the first place to look, since a kink, ice, a clog or a hose set too high can all stop the flow.

Is 55 inches an important number?

Yes. The guidance names a drain hose more than 55 inches (1.4 m) above the floor as a cause, so check where your hose is hooked up before blaming the washer.

Should I unplug the washer first?

Yes. The guidance asks you to unplug the washer or disconnect power before checking the hose. Keep towels handy because water may remain in the tub or hose.

Book a visit

Still seeing A10?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107