Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Model library · Whirlpool Dryer

WGD4810BQ

Whirlpool WGD4810BQ 29-Inch Gas Dryer Repair

Book a Service Call(713) 589-6107

Most common issues on this model

  1. Igniter glowing but the burner not lighting
  2. Gas valve coils opening and closing during a cycle
  3. Lint packed into the vent run behind a 29-inch cabinet
  4. Drum rollers and belt noise
  5. Gas shutoff and flex connector at the back panel

The WGD4810BQ is a Whirlpool gas dryer, 29 inches wide. The number also turns up with the suffixes WGD4810BQ0 and WGD4810BQ1, so two machines that look alike can still take different parts.

A dryer this wide often replaces a narrower one in a Houston garage utility corner or a laundry room with a rear gas stub-out. When one of these tumbles without heat, we watch the start-up sequence: igniter glow, valve click, flame. If the flame drops out partway through a load, the cause is often a weak coil or a vent that cannot clear the exhaust.

Before ordering anything we read the model and serial label inside the door opening and confirm the complete number with its last digits. You get a written price first, and the repair carries our 30-day workmanship warranty.

Key features

  • Cabinet 29 inches wide
  • Runs on gas
  • Number appears with 0 and 1 endings
→Codes

Error codes this model can show

tSWhirlpool Dryer Code tS: Thermistor Reading Out of Range Water TankWhirlpool Dryer Message Water Tank: Tank Full or Not Seated LocWhirlpool Dryer Code Loc: Control Lock Turned On by Mistake PFWhirlpool Dryer PF Code: Power Failure During a Cycle F6E2Whirlpool Tower Dryer Code F6E2: Control Link Check with Five-Minute Reset F6E3Whirlpool Dryer F6E3 Code: Control Alert on Three Models F6E4Whirlpool Laundry Tower Dryer F6E4 Code: Control Communication with the Panel F6E5Whirlpool Laundry Tower Dryer Code F6E5: Control Link Lost
WGD4810BQWGD4810BQ questions
My gas dryer lights, then goes out a minute later. What is happening?

When a gas dryer starts and then loses flame, the usual suspects are a restricted vent, a tired gas valve coil or a flame sensing part. We test airflow first, since heat trapped in the cabinet shuts the burner down.

Does the 0 or 1 at the end of WGD4810BQ matter?

It can. Suffixes mark revisions, and some parts differ between them. We copy the full number from the model and serial label before we look up a part.

Can a 29-inch gas dryer be repaired in a garage closet?

Yes, as long as we can pull the unit forward to reach the back panel, gas connector and vent. We check the connector for leaks and the duct for lint before we leave.

Book a visit

Book repair for your WGD4810BQ

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 589-6107