Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Error code · Washer

Whirlpool Laundry Center Washer Code E4: Lid Opened During the Spin

E4 on an older Whirlpool stacked laundry center washer means the lid was opened while the machine was in its spin cycle. The control stops the drum for safety and shows E4 until the lid is…

Low risk · DIY check OK
Book a Service Call(713) 589-6107
Code
E4
Appliance
Washer
Brand
Whirlpool
Warranty
30-day workmanship

What E4 means

E4 on an older Whirlpool stacked laundry center washer means the lid was opened while the machine was in its spin cycle. The control stops the drum for safety and shows E4 until the lid is shut. After you close the lid, washer operation resumes. If it keeps appearing with the lid down, the lid switch may not be registering. Units this old are common in many homes. We repair them, and if a repair would not be worth it we tell you plainly.

Common causes of E4

  • Lid lifted or not fully shut during the spin
  • Something on the lid edge or hinge holding it slightly open
  • A lid switch that does not register a closed lid
✓ One safe check you can try

1. Close the lid firmly; washer operation will resume. 2. Check that no clothing or detergent bottle is keeping the lid from shutting flat. 3. Wipe the rim where the lid meets the cabinet. 4. Run a short spin to see whether E4 comes back with the lid closed.

! Why to stop there
  • If E4 shows with the lid fully closed, the switch or its circuit is in question and we test it.
  • We confirm the lid closes squarely before we look deeper.
  • We give you a written price first, and say plainly if an older unit is not worth the repair.
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Washer codes

Multiple Lights FlashingWhirlpool Top-Load Washer with Several Lights Flashing: Out-of-Balance Load No Water DetectedWhirlpool Front-Load Washer Message "No Water Detected": What to Check OFb or ofbWhirlpool Top-Load Washer Code OFb or Ofb: Load Out of Balance oLWhirlpool Top-Load Washer Code oL: Overloaded Tub PFWhirlpool Washer Code PF: Power Failure During the Cycle Rinse Light OnWhirlpool Top-Load Washer Rinse Light On: Spray Rinse in Progress rLWhirlpool Front-Load Washer Code rL: Items Found During Clean Washer LdWhirlpool Top-Load Washer Code Ld: Water Is Slow to Leave the Tub
E4E4 questions
Why did E4 appear in the middle of a cycle?

The lid was lifted during the spin. The washer stops the drum for safety and waits, and closing the lid lets it carry on with the cycle where it left off.

It shows E4 with the lid down. Now what?

Check for an obstruction at the lid edge first, such as a sleeve or a bottle. If it is clear, the lid switch may not be signaling that the lid is closed, which we can test.

Is the lid switch repair worth it on an old unit?

Often it is a modest repair. We quote first and say plainly if the laundry center's age makes it a poor use of your money.

Book a visit

Still unsure about E4?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107