Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Error code · Dryer

Whirlpool Dryer Codes F10 to F24: Unplug for Half an Hour

The range F10 through F24 covers a block of codes on Whirlpool electric and gas dryers in the WED and WGD series, Cabrio and Duet generations included, such as the WGD5000DW. The brand names no part…

Medium · inspection needed
Book a Service Call(713) 589-6107
Code
F10 to F24
Appliance
Dryer
Brand
Whirlpool
Warranty
30-day workmanship

What F10 to F24 means

The range F10 through F24 covers a block of codes on Whirlpool electric and gas dryers in the WED and WGD series, Cabrio and Duet generations included, such as the WGD5000DW. The brand names no part and gives one routine: turn off and unplug the dryer, wait about half an hour, then plug in and run a cycle again. Owners see an F-number in this range and the dryer stops. Which circuit it refers to depends on the exact number.

Common causes of F10 to F24

  • Control board reading that clears after a rest
  • Connections to the control
  • Sensor or drive circuit tied to the exact number
  • A passing electronic error
✓ One safe check you can try

1. Turn off and unplug the dryer. 2. Leave it unplugged for about half an hour. 3. Plug it back in and start the program or cycle again. 4. If the failure persists, call us with the exact number you saw.

! Why to stop there
  • The exact number in the range points to a particular circuit, and a reset does not tell us which
  • A code that returns after the rest points to a real issue
  • We read the number, test that circuit, and quote in writing first
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Dryer codes

LocWhirlpool Dryer Code Loc: Control Lock Turned On by Mistake PFWhirlpool Dryer PF Code: Power Failure During a Cycle tSWhirlpool Dryer Code tS: Thermistor Reading Out of Range Water TankWhirlpool Dryer Message Water Tank: Tank Full or Not Seated F7E2Whirlpool Tower Dryer F7E2 Code: Fan Circuit on Ventless, Control Unit on Stacked F7E3Whirlpool Ventless Tower Dryer Code F7E3: Compressor Circuit in the Cooling System F7E6Whirlpool Laundry Tower Dryer F7E6 Code: Motor Circuit Check on the Dryer F9E2Whirlpool Dryer Code F9E2: Water Tank Full, or Reset Only
F10 to F24F10 to F24 questions
Why do I need to wait half an hour?

The routine for F10 to F24 is to unplug the dryer and leave it for about half an hour before plugging it in and running a cycle again.

Do all F10 to F24 codes mean the same thing?

They share one owner routine, but each number points to its own circuit. Please note the exact number so we can prepare before the visit.

What if the code is back right away?

Then the condition is still present. Do not keep restarting. Call us with the number and the model, and we test before suggesting any part.

Book a visit

Still seeing F10 to F24?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107