Error code · Washer

Whirlpool Laundry Tower Washer Code F3E6: Rotor Sensor Reading Flagged by the Control

Medium · inspection needed

Code: F3E6
Appliance: Washer
Brand: Whirlpool
Warranty: 30-day workmanship

What F3E6 means

F3E6 on the washer section of a Whirlpool laundry tower or stacked laundry center points to the rotor sensor. That sensor lets the control know the motor is turning the way it should. When it reports a problem, the washer usually stops mid-cycle or will not start, and the display shows the code. The only owner step offered for this code is a power reset, and no model number is named.

Common causes of F3E6

Rotor position sensor circuit
Wiring between the motor and control
Control reading on the drive

✓ One safe check you can try

1. Unplug the laundry tower for 5 minutes so the control resets. 2. Plug it back in and check that the door or lid is closed and the load is balanced. 3. Run a short cycle. 4. If F3E6 returns, schedule service so we can look at the drive circuit.

! Why to stop there

A reset cannot tell us whether the sensor, wire or control caused the reading.
We test the drive circuit for the washer section only.
Our price is written down before we open anything on the drive side.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Lo FLWhirlpool Front-Load Washer Code Lo FL: Not Detecting Enough Incoming Water What does the "SUD" or "SD" meanWhirlpool Washer Display SUD or SD: What It Means and How to Clear It LoCWhirlpool Front-Load Washer LoC or LC: Control Lock Is Switched On Multiple Lights FlashingWhirlpool Top-Load Washer with Several Lights Flashing: Out-of-Balance Load No Water DetectedWhirlpool Front-Load Washer Message "No Water Detected": What to Check OFb or ofbWhirlpool Top-Load Washer Code OFb or Ofb: Load Out of Balance oLWhirlpool Top-Load Washer Code oL: Overloaded Tub PFWhirlpool Washer Code PF: Power Failure During the Cycle

F3E6F3E6 questions

What is the rotor sensor?

It tells the control whether the motor is turning as expected. F3E6 on a laundry tower washer section points to that circuit, though a code alone does not name a failed part. We test before suggesting any replacement.

Will the dryer on my tower still run?

The code concerns the washer section. The dryer may still run, but check it separately and tell us if both sections act up, because a shared power or control issue would change what we look at first.

Is a reset enough for F3E6?

A 5-minute unplug can clear a one-time glitch. If the code returns, the circuit needs testing, and we give a written price before any repair and back the work with a 30-day workmanship warranty.

Book a visit

Still seeing F3E6?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107