Error code · Washer

Whirlpool Stacked Laundry Center Code F 23: Reset the Control and Retry

F 23 is one of the codes older Whirlpool stacked laundry centers show on the washer side. The owner guidance is limited to a power reset, and nothing in it ties F 23 to a particular…

Medium · inspection needed

(713) 589-6107

Code: F 23
Appliance: Washer
Brand: Whirlpool
Warranty: 30-day workmanship

What F 23 means

F 23 is one of the codes older Whirlpool stacked laundry centers show on the washer side. The owner guidance is limited to a power reset, and nothing in it ties F 23 to a particular part, so we read it as a control-level stop and not as a verdict on any one part. On the display you see F 23 and the washer does not carry on. Many of these older units are still in service across Houston, and we repair them when the numbers make sense.

Common causes of F 23

A momentary control lockup that a reset clears
A control board or connection problem if F 23 returns after the reset
Power quality at the outlet shared with other appliances

✓ One safe check you can try

1. Unplug the washer and let it rest for 2 to 5 minutes. 2. Push the plug fully back into the outlet. 3. Make sure the lid or door is shut and start a short cycle. 4. If F 23 is still on the display, stop there and arrange service.

! Why to stop there

Nothing in the display says which circuit set F 23, so a reset is a test and not a fix.
When the code repeats, we check the control and its wiring on site.
We say plainly whether repairing a laundry center of this age is a good use of your money.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Washer codes

Lid Lock FlashingWhirlpool Top-Load Washer Lid Lock Light Flashing: Lock Fails to Engage Water Tap is ClosedWhirlpool Washer Symbol "Water Tap Is Closed": Water Is Not Arriving Lo FLWhirlpool Front-Load Washer Code Lo FL: Not Detecting Enough Incoming Water What does the "SUD" or "SD" meanWhirlpool Washer Display SUD or SD: What It Means and How to Clear It LoCWhirlpool Front-Load Washer LoC or LC: Control Lock Is Switched On Multiple Lights FlashingWhirlpool Top-Load Washer with Several Lights Flashing: Out-of-Balance Load No Water DetectedWhirlpool Front-Load Washer Message "No Water Detected": What to Check OFb or ofbWhirlpool Top-Load Washer Code OFb or Ofb: Load Out of Balance

F 23F 23 questions

What should I do first when F 23 shows?

Unplug the washer for 2 to 5 minutes, plug it back in and try a short cycle. That reset is the only owner step for this code.

Does F 23 mean the whole laundry center is dead?

No. It is a stop on the washer side, and many units go on working after a reset. A repeat is what tells us a repair visit is needed.

Why can't you tell me the cause by phone?

Because the code names no part. We have to look at the control and the washer's circuits in person, and we give you a written price first.

Book a visit

Still seeing F 23?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107