Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Error code · Dryer

Whirlpool Dryer Bottom Filter Symbol: Blocked or Not Seated

Some Whirlpool electric and gas dryers in the WED and WGD series, Cabrio and Duet generations included, show a bottom filter symbol on the display. It appears for two reasons: the bottom filter is blocked by…

Low risk · DIY check OK
Book a Service Call(713) 589-6107
Code
Bottom Filter Issues
Appliance
Dryer
Brand
Whirlpool
Warranty
30-day workmanship

What Bottom Filter Issues means

Some Whirlpool electric and gas dryers in the WED and WGD series, Cabrio and Duet generations included, show a bottom filter symbol on the display. It appears for two reasons: the bottom filter is blocked by lint, or it is not positioned correctly in its compartment. Owners notice the symbol and, often, longer drying times. This is a maintenance indicator and not a control failure, so the fix usually takes a few minutes at home.

Common causes of Bottom Filter Issues

  • Bottom filter loaded with lint
  • Filter not pushed fully into its compartment
  • Release levers not in the vertical position
  • Flap not fully closed over the filter
✓ One safe check you can try

1. Take out the bottom filter and clean it, then insert it properly afterward. 2. If it was not seated correctly, push the bottom filter in and move the release levers into a vertical position. 3. Close the flap. 4. Refer to the owner's manual for cleaning the bottom lint filter if you are unsure how it comes out.

! Why to stop there
  • If the symbol stays after a clean filter is seated, the sensing or the compartment needs a look
  • Lint that has built up past the filter can restrict airflow in ways you cannot see
  • We inspect the filter area and airflow, and quote in writing before any repair
Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.
→Same appliance

Other Dryer codes

LocWhirlpool Dryer Code Loc: Control Lock Turned On by Mistake PFWhirlpool Dryer PF Code: Power Failure During a Cycle tSWhirlpool Dryer Code tS: Thermistor Reading Out of Range Water TankWhirlpool Dryer Message Water Tank: Tank Full or Not Seated FEWhirlpool Dryer Code FE: Power Source Problem at the Outlet hEWhirlpool Dryer hE Code: Heating Error, Too Low or Too High L2Whirlpool Dryer Code L2: Low Line Voltage at the Dryer LFWhirlpool HybridCare Dryer Code LF: Lint Filter Missing
Bottom Filter IssuesBottom Filter Issues questions
What does the bottom filter symbol mean?

Either the bottom filter is clogged with lint or it is not seated correctly. Cleaning it and pushing it in fully, with the levers vertical, resolves most cases.

Where are the release levers?

They are part of the bottom filter compartment. After inserting the filter, move them into the vertical position, then close the flap. Your owner's manual shows the layout for your model.

The symbol is still on. What next?

If the filter is clean and seated and the symbol remains, the sensing or the compartment may be at issue. We can inspect it and give you a written price.

Book a visit

Still unsure about Bottom Filter Issues?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107