Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Model library · Whirlpool Range

YWFES7030SW

Whirlpool YWFES7030SW Appliance Repair with Written Quote

Book a Service Call(713) 589-6107

Most common issues on this model

  1. Hot cooktop that stays on after the knob is turned off
  2. Oven that preheats on only one element
  3. Burner knob with a loose or spinning stem
  4. Cooling fan that runs long after use

The YWFES7030SW is a free-standing electric range. Its listing shows two endings, YWFES7030SW0 and YWFES7030SZ0. It is a floor-standing unit with a 240-volt supply and no gas line, so every heat source on it is an electric element.

Wear on the controls is often what brings us to a range of this type. A knob with a loose stem can turn without moving the switch behind it. A cooktop element that stays hot after shutoff may have a stuck switch, and we treat that as a safety matter: we shut power at the breaker and test the switch before it is used again. In the oven we confirm that both bake and broil elements take turns, since an oven on only one element heats slowly.

The plate on the range tells us whether it is a YWFES7030SW0 or a YWFES7030SZ0, and we order parts to match. Pricing is written before we start, and our labor has a 30-day warranty.

Key features

  • Free-standing electric range
  • Also sold as YWFES7030SW0 and YWFES7030SZ0
  • Plugs into a 240-volt outlet
→Codes

Error codes this model can show

PUSH or PSHWhirlpool Range PUSH or PSH: Start Was Not Pressed Sabbath ModeWhirlpool Range Sabbath Mode: Why the Oven Stays On Sabbath, Sab, 5Ab, or 5A7Whirlpool Range Sabbath, Sab, 5Ab or 5A7: Canceling the Mode FEE6Whirlpool Range Code FEE6: Bake Element Circuit FEE7Whirlpool Range Code FEE7: Checking the Broil Element Circuit FEE8Whirlpool Range Code FEE8: Oven Reset, No Part Named Indicator FlashingWhirlpool Range Indicator Flashing: Stuck Key or Control Setting Indicator or Hot Light OnWhirlpool Range Hot Light On: Control Still On or Surface Hot
YWFES7030SWYWFES7030SW questions
A burner stays hot after I turn the knob off. What should I do?

Switch off the range at the breaker and do not use that burner. A stuck burner switch is the likely cause. We test and replace it before the range goes back into service.

Why does my oven heat slowly?

If only one of the two oven elements is working, or the sensor reads low, preheat takes much longer. We test both elements and compare the sensor with a thermometer.

The knob spins but nothing changes. Is that a switch problem?

It can be the knob, its stem, or the switch shaft. We pull the knob and check how it seats on the shaft, which is a quick test before replacing any switch.

Book a visit

Book repair for your YWFES7030SW

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 589-6107