Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Model library · Whirlpool Range

YWFES5030RB

Whirlpool YWFES5030RB Free-Standing Electric Range Troubleshooting and Repair

Book a Service Call(713) 589-6107

Most common issues on this model

  1. Element that stays dim while the others glow bright
  2. Oven that overshoots, then cools well below the set point
  3. Receptacle that is loose in the cooktop
  4. Knob that must be held in a certain position to heat

The YWFES5030RB is a free-standing electric range. It stands on the floor, plugs into a 240-volt wall outlet, and has the elements on top with the oven below. It is typical of the ranges in Houston houses where the kitchen has not been remodeled in years.

We approach a range like this by comparing one burner against another. If one element glows dimmer than the rest, or needs the knob held in a certain spot, the switch or receptacle is a likelier cause than the element. In the oven, a swing in temperature, where it overshoots and then falls well below the setting, makes us look at the sensor and the control before replacing the element.

With four endings listed, among them YWFES5030RB0, YWFES5030RV0 and YWFES5030RW0, we read the plate before ordering. The estimate is written ahead of the work, and our labor carries a 30-day warranty.

Key features

  • Free-standing electric range
  • Also sold as YWFES5030RB0, YWFES5030RV0 and YWFES5030RW0
  • Four listed revision endings
  • 240-volt household supply
→Codes

Error codes this model can show

PUSH or PSHWhirlpool Range PUSH or PSH: Start Was Not Pressed Sabbath ModeWhirlpool Range Sabbath Mode: Why the Oven Stays On Sabbath, Sab, 5Ab, or 5A7Whirlpool Range Sabbath, Sab, 5Ab or 5A7: Canceling the Mode PowerLossWhirlpool Range and Wall Oven PowerLoss: Reset the Time Press Cancel to ResetWhirlpool Range Message "Press Cancel to Reset": What to Do Probe or Insert ProbeWhirlpool Range Probe Message: Meat Probe Not Detected FEE6Whirlpool Range Code FEE6: Bake Element Circuit FEE7Whirlpool Range Code FEE7: Checking the Broil Element Circuit
YWFES5030RBYWFES5030RB questions
Why does one burner glow dimmer than the rest?

A dim element usually has a worn coil, a poor receptacle contact, or a switch that sends only part of the power. We compare resistance and inspect the terminals to see which one it is.

What causes oven temperature swings on an electric range?

A drifting oven sensor or a control that cycles the element too early or too late is the usual reason. We test the sensor value against a thermometer before replacing any part.

Do all four endings share the same parts?

Many parts are shared, but revisions can change switches or controls. We read the label for the exact ending and match parts to it rather than assuming.

Book a visit

Book repair for your YWFES5030RB

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 589-6107