Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Model library · Whirlpool Range

YWFE770H0FZ

Whirlpool YWFE770H0FZ Fix for Freestanding Electric Range

Book a Service Call(713) 589-6107

Most common issues on this model

  1. Surface element that cycles off while a pan is still cooking
  2. Oven display lit but no bake or broil heat
  3. Element terminals that look pitted or discolored
  4. Oven light or fan noise that changes during preheat

The YWFE770H0FZ is a freestanding electric range. It is the kind of range that sits on the floor with finished sides, usually in an open kitchen or at the end of a counter run, and it is wired to a 240-volt outlet. This number is listed with one revision, YWFE770H0FZ0.

For an electric range of this type, we check what a cook would notice first. Does every surface element come up to heat, does the oven reach temperature in a reasonable time, and does the broil element glow across its full length? A cold zone points us to the element, receptacle or switch. A dead oven with a working cooktop points us to the oven elements, sensor or control.

Once the plate on the range confirms the revision, we order the matching part. The estimate comes in writing first, and our labor is warranted for 30 days.

Key features

  • Electric freestanding range
  • Runs on household 240-volt power
  • Single revision listed: YWFE770H0FZ0
→Codes

Error codes this model can show

PUSH or PSHWhirlpool Range PUSH or PSH: Start Was Not Pressed Sabbath ModeWhirlpool Range Sabbath Mode: Why the Oven Stays On Sabbath, Sab, 5Ab, or 5A7Whirlpool Range Sabbath, Sab, 5Ab or 5A7: Canceling the Mode Indicator or Hot Light OnWhirlpool Range Hot Light On: Control Still On or Surface Hot Lo or PreWhirlpool Range Lo or Pre: Low Temperature and Preheating LOCLOC on a Whirlpool Range or Wall Oven: Control Lock Is On LockWhirlpool Range Cooktop Lock: Unlocking the Surface Controls PowerLossWhirlpool Range and Wall Oven PowerLoss: Reset the Time
YWFE770H0FZYWFE770H0FZ questions
Why would the cooktop work but the oven stay cold?

The cooktop and oven use separate elements and controls. If the surface heats and the oven does not, we test the bake element, the oven sensor and the control relay in that order.

How can I tell a failed surface element from a bad receptacle?

A failed element usually shows a break or blister, while a bad receptacle shows burn marks or a loose fit. We swap-test the element and inspect the terminals, which settles it without replacing both.

Is there more than one version of the YWFE770H0FZ?

This number is listed with the YWFE770H0FZ0 ending. We still read the label on your range to confirm the version, since that is what we match parts against.

Book a visit

Book repair for your YWFE770H0FZ

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 589-6107