Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Model library · Whirlpool Range

YWFE550S0LB

Whirlpool YWFE550S0LB Electric Range Repair

Book a Service Call(713) 589-6107

Most common issues on this model

  1. Control panel that does not respond to touch
  2. Oven that stops mid-cycle
  3. Element wiring harness near the back of the oven
  4. Burner switch that sticks between settings

Our records show the YWFE550S0LB as an electric freestanding range with many finish variants. For Houston homeowners, the most frequent request on a range like this is for an oven that stops mid-cycle or a panel that no longer responds. We look at those issues from the supply forward, so we do not blame the control for a wiring problem.

The start is a voltage check and a look at the element harness behind the oven, where heat wears insulation over time. After that, we test the control panel with the range powered up, press each key and watch for a response. A burner switch that sticks between settings is a separate item that we test off the control.

Because the base number also appears as YWFE550S0LB0, YWFE550S0LV2 and YWFE550S0LZ3, we confirm your model and serial label before ordering parts. The price is written ahead of time, and the job has a 30-day workmanship warranty.

Key features

  • Electric range
  • Freestanding design
  • Further variants named YWFE550S0LB0
→Codes

Error codes this model can show

PUSH or PSHWhirlpool Range PUSH or PSH: Start Was Not Pressed Sabbath ModeWhirlpool Range Sabbath Mode: Why the Oven Stays On Sabbath, Sab, 5Ab, or 5A7Whirlpool Range Sabbath, Sab, 5Ab or 5A7: Canceling the Mode FEE8Whirlpool Range Code FEE8: Oven Reset, No Part Named Indicator FlashingWhirlpool Range Indicator Flashing: Stuck Key or Control Setting Indicator or Hot Light OnWhirlpool Range Hot Light On: Control Still On or Surface Hot Lo or PreWhirlpool Range Lo or Pre: Low Temperature and Preheating LOCLOC on a Whirlpool Range or Wall Oven: Control Lock Is On
YWFE550S0LBYWFE550S0LB questions
My oven stops in the middle of baking. What is the cause?

A mid-cycle stop may come from a failing sensor, a heat-damaged wire or a control that drops out. We check the wiring and sensor first, since those are cheaper to repair than a control.

Why does my touch panel ignore some keys?

Moisture, grease or a worn contact behind the panel can make keys unresponsive. We inspect and test the panel with power on and replace the control only when testing shows it has failed.

Do all YWFE550S0LB versions use the same parts?

Not always. Endings can mark small revisions, and controls or wiring can differ. We use the full label to match each part so the repair does not have to be redone.

Book a visit

Book repair for your YWFE550S0LB

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 589-6107