Booking today · Houston service windows 9–12 · 1–4 · 4–7 Independent Whirlpool specialists · Licensed & insured Mon–Fri 7:00 AM - 8:00 PM · Sat 8:00 AM - 6:00 PM
(713) 589-6107 Book a Service Call
Model library · Whirlpool Dryer

WGD9600TA

Whirlpool WGD9600TA Gas Dryer Repair

Book a Service Call(713) 589-6107

Most common issues on this model

  1. Igniter glowing but the burner never lighting
  2. Burner shutting off partway through a load
  3. Lint buildup in the exhaust duct and lint screen housing
  4. Drum roller, idler pulley and belt noise
  5. Gas shutoff valve and flex connector at the wall

The WGD9600TA is a Whirlpool gas dryer with a 27-inch cabinet. The same number is also found with endings like WGD9600TA0, WGD9600TA1 and WGD9600TB0, and a letter or digit change can mean a different part list.

Gas dryers of this width usually sit in a Houston laundry room or garage utility space with a gas stub-out behind the cabinet. When one runs but the clothes stay damp, we start with the burner sequence: igniter glow, valve opening, steady flame. Then we check the exhaust path, because a long duct run through an attic holds lint and shuts the burner down early.

No part is ordered until the complete number has been read off the model and serial label. You see a written price first, and the workmanship is covered for 30 days.

Key features

  • Cabinet 27 inches wide
  • Runs on gas
  • Sold under the same number with endings such as WGD9600TA0, WGD9600TA1 and WGD9600TB0
→Codes

Error codes this model can show

PFWhirlpool Dryer PF Code: Power Failure During a Cycle tSWhirlpool Dryer Code tS: Thermistor Reading Out of Range Water TankWhirlpool Dryer Message Water Tank: Tank Full or Not Seated LocWhirlpool Dryer Code Loc: Control Lock Turned On by Mistake F6E2Whirlpool Tower Dryer Code F6E2: Control Link Check with Five-Minute Reset F6E3Whirlpool Dryer F6E3 Code: Control Alert on Three Models F6E4Whirlpool Laundry Tower Dryer F6E4 Code: Control Communication with the Panel F6E5Whirlpool Laundry Tower Dryer Code F6E5: Control Link Lost
WGD9600TAWGD9600TA questions
My dryer spins but the clothes come out cold. Where do you start?

On a gas dryer of this type we watch the igniter and gas valve through a start-up, then test airflow in the vent. A glowing igniter with no flame points toward the valve coils; a flame that quits points toward airflow.

Does the ending on WGD9600TA matter when I need a part?

Yes. Endings like 0, 1 or a changed letter can mark a revision with different parts. We read the model and serial label on the cabinet and match the complete number before we order anything.

Is a gas leak check part of the visit?

Whenever we pull a gas dryer out, we inspect the shutoff valve and flex connector for damage and test the joints with a leak solution. If the connector is aged or kinked, we say so and quote a replacement.

Book a visit

Book repair for your WGD9600TA

Book in about a minute, or call the desk. Same-day windows inside the Loop on most days, next-day across the rest of Houston.

(713) 589-6107