Error code · Dryer

Whirlpool Laundry Tower Dryer Code F2E3: Lost Communication with the Tower Control

Medium · inspection needed

Code: F2E3
Appliance: Dryer
Brand: Whirlpool
Warranty: 30-day workmanship

What F2E3 means

F2E3 is a communication error code for the dryer section of a Whirlpool laundry tower or stacked laundry center. The dryer control and another board in the tower are not exchanging messages correctly, so the dryer shows the code and may not start. The washer half can keep working, which makes it look like only part of the tower is affected. The listed approach is a short power reset first, then service if the code remains.

Common causes of F2E3

Connections between the dryer control and the tower's other board
Condition of the wiring harness between sections
How the control starts back up after a reset
Moisture or heat exposure near the control

✓ One safe check you can try

1. Disconnect the tower from power for one full minute. 2. Plug it in or restore the breaker, then select a timed dry cycle. 3. Watch the display for a minute to see whether F2E3 comes back. 4. If it does, stop using the dryer section and schedule service rather than resetting repeatedly.

! Why to stop there

A message problem between boards may sit in the wiring, in either board, or in the interface
We test the link before suggesting any replacement
On an older tower we tell you plainly if a repair makes sense, with the price written out first

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dryer codes

LocWhirlpool Dryer Code Loc: Control Lock Turned On by Mistake PFWhirlpool Dryer PF Code: Power Failure During a Cycle tSWhirlpool Dryer Code tS: Thermistor Reading Out of Range Water TankWhirlpool Dryer Message Water Tank: Tank Full or Not Seated F7E3Whirlpool Ventless Tower Dryer Code F7E3: Compressor Circuit in the Cooling System F7E6Whirlpool Laundry Tower Dryer F7E6 Code: Motor Circuit Check on the Dryer F9E2Whirlpool Dryer Code F9E2: Water Tank Full, or Reset Only FCE1Whirlpool Dryer FCE1 Code: Breaker Reset Only

F2E3F2E3 questions

What does a communication error on my tower mean?

The dryer's control cannot trade messages with another part of the tower. It is a signal path condition, not a statement that the motor or heater is bad, so we trace the link before touching parts.

Will the reset clear F2E3 for good?

Sometimes it does, especially after a brief electrical hiccup. If the code returns within a few cycles, the link is likely marginal and a technician should test it.

Can I still wash while the dryer shows F2E3?

Often yes, since the washer runs on its own cycle. We would not keep using the dryer section until the code is resolved, because an unstable control can interrupt a load.

Book a visit

Still seeing F2E3?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107