Error code · Wall Oven

Whirlpool Wall Oven Code F1 E6: Reading from the Microwave Thermistor

Medium · inspection needed

Code: F1 E6
Appliance: Wall Oven
Brand: Whirlpool
Warranty: 30-day workmanship

What F1 E6 means

On Whirlpool built-in wall ovens with a microwave section, for example the WOC54EC7HS, F1 E6 refers to the microwave thermistor or sensor, or the wiring that carries its signal. The oven does not say whether the sensor, its connection, or something else is behind the code. You will see F1 E6 on the display, and microwave cooking may be blocked until the code is cleared or the cause is found.

Common causes of F1 E6

Microwave thermistor or temperature sensor
Sensor connector or harness wiring
Control reading the sensor signal

✓ One safe check you can try

1. Cut power to the oven at its panel breaker and let a full minute pass. 2. Restore the breaker. 3. Keep the display in view for sixty seconds, looking for F1 E6. 4. Run a quick oven test and a quick microwave test if the display stays clean.

! Why to stop there

Clearing F1 E6 does not show whether the sensor reading was wrong or the wiring was loose.
We check the sensor circuit and the connection before we suggest any part.
If the sensor reads normally, we move on to the control that interprets it.

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Wall Oven codes

9d42Whirlpool Wall Oven Code 9d42: Door Message That Will Not Clear 9d51Whirlpool Wall Oven Code 9d51: Door Sensing When Heat Will Not Start 9d52Whirlpool Wall Oven Code 9d52: Door Code on a Combination Oven 9d61Whirlpool Wall Oven Code 9d61: Reset Steps If the Door Will Not Latch 9d62Whirlpool Wall Oven Code 9d62: Last of the Door Codes Call ServiceWhirlpool Wall Oven Message "Call Service": Cancel and Reset Demo ModeWhirlpool Wall Oven Message "Demo Mode": Turning It Off Door in Microwave DisplayWhirlpool Wall Oven Message "Door in Microwave Display": Door Switch Input

F1 E6F1 E6 questions

What does the microwave thermistor do?

It reports a temperature to the oven's control so the microwave section can run safely. When the control cannot read it properly, it posts F1 E6 and may stop the microwave from running.

Will the regular oven still bake with F1 E6?

Sometimes it will, since the code names the microwave side. Do not count on it, though. If the display keeps locking up, we check how the whole oven responds.

Why does a reset sometimes fix it?

A brief power loss can let the control restart and read the sensor fresh. If F1 E6 returns, the cause is still there, and we trace it rather than keep resetting.

Book a visit

Still seeing F1 E6?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107