Error code · Dishwasher

Whirlpool Dishwasher Code F9E2: Drain Motor Circuit Check

Medium · inspection needed

Code: F9E2
Appliance: Dishwasher
Brand: Whirlpool
Warranty: 30-day workmanship

What F9E2 means

F9E2 is a drain motor error on Whirlpool built-in dishwashers, the family that includes the WDF330PAHB. The motor that pumps used water out is not responding as the control expects, so the dishwasher cannot empty the tub. You will see the code, water may stay in the bottom after the cycle, and the dishwasher may stop. On a new install, a missing disposer knockout plug or a badly routed drain hose can look very similar.

Common causes of F9E2

Drain motor and its connection
Drain hose routing, kinks, or clogs
Disposer knockout plug left in on a new installation
Control drive signal to the drain motor

✓ One safe check you can try

1. On a new installation, make sure the garbage disposer knockout plug was removed. 2. Check the disposer and drain for clogs. 3. Straighten the drain hose if it is kinked, since a kinked or clogged hose causes poor drainage or none at all. 4. Verify the drain hose is routed correctly, on the right side and inside the frame. 5. Cycle the power. If F9E2 returns, schedule service.

! Why to stop there

The hose and plug are easy to check, but the drain motor and its drive are not visible from outside
A partly clogged drain can strain the motor and mimic a failure
We test the pump circuit and trace the drain path, and give a written price before work

Opening a panel yourself does not automatically cancel a manufacturer warranty, but it can cause accidental damage, and some manufacturers set their own service conditions. Check your warranty terms, or ask us, before deciding.

→Same appliance

Other Dishwasher codes

F8E4Whirlpool Dishwasher F8E4 Error on a New Install: Fill and Float Checks F8E5Whirlpool Dishwasher Code F8E5: Fill Valve Stuck Open, Act Now F9E1Whirlpool Built-In Dishwasher F9E1 Means Water Is Draining Too Slowly FAE4Whirlpool Dishwasher FAE4 or F10E4 Points to the Diverter Valve FAE5Whirlpool Dishwasher FAE5 or F10E5: A Diverter Leak H2OWhirlpool Dishwasher H2O on the Display: No Water Detected Rinse Only LightWhirlpool Portable Dishwasher with the Rinse Only Light Flashing: Stuck Keys SaniLightWhirlpool Dishwasher Sanitize Light Blinking Because the Water Was Not Hot Enough

F9E2F9E2 questions

Is F9E2 always a bad drain motor?

No. A kink, a clog, or an unremoved disposer plug can raise it as well. We check the drain path first so you only pay for a motor if the motor is the problem.

The tub is full of water. What now?

Do not force another cycle. Check the hose and disposer, cycle the power, and if the water stays, call us. Keep the dishwasher off until the water is cleared.

Do you handle new-install drain problems?

Yes. If the hose routing or disposer plug is the cause, we correct it, confirm the dishwasher drains, and tell you the written price before starting.

Book a visit

Still seeing F9E2?

A technician diagnoses it on site and gives you the price in writing before any work starts.

(713) 589-6107